Zendo Cooler   

2 Point Connection - Connect to Solar and Connect to Battery

Pre Order

New!

The Zendo Cooler is a side draft solar and battery powered evaporative cooler that runs directly off of solar and battery.  An integrated solar charge controller makes this unit easy to connect to solar panel and battery.   This unit features battery stabilized daytime running and night time running.  Charge and power your cooler with a direct solar plugin. Store charge and power your cooler with a 12 volt battery. Programable for 12/24/36 volt solar power upto 30 amps.  Programable for 12 volt SLA AGM or LifePo battery. 

With wireless on/off, you can easily control when your unit turns on or off. The Zendo also features a standard 1/4 inch water float valve connection that can be supplied by both gravity feed and municipal water supply. This easy to install design makes it great for commercial, industrial and residential use. Great performance means more efficient cooling than standard units using aspen pads. And with a standardized cabinet the Zendo can often fit in existing cooler locations. Rough opening required for installation is 21x21 inches, blowing cooled air directly into your space.

Mounting and Installation:

  • For Standard Side Draft Cooler Fixed Mount Installation
  • Exterior Mounting for cooling indoor space
  • Through wall or window opening required
  • Rough Space Opening Required:  21 X 21 inch Square opening
  • Bottom of cooler water over flow drain (standard)



The Zendo cooler also features  a 1/4 inch float valve connection (standardize evaporative cooler water connection) which can be supplied by both gravity feed and also municipal water supply connected.

Cool your space with solar!

Features:

  • 30 amp Integrated digital programmable controller 
  • Wireless On/Off
  • Power it with a single residential solar panel or 12v/24v solar panel array
  • 2500 CFM Airmovement
  • 73 Fahrenheit output with 100 degrees 10% humidity input
  • 12v Operating System
  • Brushless motors
  • Standardized Cabinet
  • Standardized evaporative cooler water connection (1/4" Float Valve)
  • One point solar connection -MC-4 direct connection
  • Grounding Lug - grounding point
  • Wide opening front exhaust (20 x 20 inches)

Powering Ratings:

  • Photovoltaic 12/24/36 Volts input
  • Amps Rating:  30 amps
  • Maximum power input:  400 Watts 
  • Minimum power requirements:  200 Watts 12 Volts

WesternHarmonics.com
Got a question? Need assistance? Feel free to get in touch!

Got a question about a product we offer?
We are here to assist!
Email: [email protected]
Phone Number 1-619-292-5179

Offices & Warehouse (Ships from this address):

3330 East Michigan Street, Unit C, Tucson, AZ 85714


Write a review

Note: HTML is not translated!
   Bad           Good
Captcha

Zendo Cooler With Integrated Controller

  • $800.00

  • Ex Tax:$800.00

Tags: Zendo Cooler, solar swamp cooler, evaporative cooler, solar evaporation cooler, solar evaporation cooler, cooling, solar powered,